Carbon Fiber Tank Cover Set - HUSQVARNA / HUSABERG 2012-2016
Description
Carbon fiber tank cover set for the Husqvarna TE/FE, 2012–2016, and Husaberg TE/FE, 2013–2014. Moulded from the original panels, so it follows the tank contours exactly and fits over the OEM bodywork with no modification and no drilling.
Resin-infused under vacuum rather than wet-laid — the laminate comes out fully compacted, light and stiff rather than just light. Edges are trimmed and finished by hand, then sealed under a two-stage clear coat.
Eleven fibers, twenty flake colors, or two fibers split across a single part. Build a full kit →
Fits:
- Husqvarna TE 125 (2012–2016)
- Husqvarna TE 250 (2012–2016)
- Husqvarna TE 300 (2012–2016)
- Husqvarna FE 250 (2012–2016)
- Husqvarna FE 350 (2012–2016)
- Husqvarna FE 450 (2012–2016)
- Husqvarna FE 501 (2012–2016)
- Husaberg TE 250 (2013–2014)
- Husaberg TE 300 (2013–2014)
- Husaberg FE 250 (2013–2014)
- Husaberg FE 350 (2013–2014)
- Husaberg FE 450 (2013–2014)
- Husaberg FE 501 (2013–2014)
Made to order. Production 4–6 weeks.
2 - stage clear coat
Two coats, cut back and polished between them. The result is a deep, wet-looking gloss that holds a straight reflection — and a UV-protected surface that stays that way.
Finished edges
Every edge is trimmed and refined by hand. No sharp transitions, no raw laminate, no rough spots where the part meets the bike.
Infusion process
Resin drawn through the dry fibre under vacuum. It compacts the laminate and leaves no dry spots or voids — the reason the part is light and stiff rather than just light.
Two fibres on one part
Forged tow running into a reflective weave on the same panel. Any two of our fibres can meet on one part, and you choose where the transition sits.
Unlimited possibilities
Eleven fibres, and the flake is whatever shade you want it to be. If the colour you are after is not in the list on this page, the Kit Builder carries the full palette — and will mix one if it is not there either.
2 - stage clear coat
Two coats, cut back and polished between them. The result is a deep, wet-looking gloss that holds a straight reflection — and a UV-protected surface that stays that way.
Finished edges
Every edge is trimmed and refined by hand. No sharp transitions, no raw laminate, no rough spots where the part meets the bike.
Infusion process
Resin drawn through the dry fibre under vacuum. It compacts the laminate and leaves no dry spots or voids — the reason the part is light and stiff rather than just light.
Two fibres on one part
Forged tow running into a reflective weave on the same panel. Any two of our fibres can meet on one part, and you choose where the transition sits.
Unlimited possibilities
Eleven fibres, and the flake is whatever shade you want it to be. If the colour you are after is not in the list on this page, the Kit Builder carries the full palette — and will mix one if it is not there either.
